Table of Contents
Advertisement
Turn-signal lever
5
4. The headlamps will come on in the low
beam setting for approximately 30 sec-
onds. After the headlamps go off, the
headlamps can be turned on again in the
low beam setting for approximately
30 seconds by pulling the turn-signal
lever towards you within 60 seconds of
putting the operation mode of the power
switch in OFF.
To turn on the headlamps again after
60 seconds of putting the operation mode
of the power switch in OFF, repeat the
process from step 1.
NOTE
While the coming home light function is
operating, perform one of the following
operations to cancel the function.
• Pull the turn-signal lever towards you.
• Turn the combination headlamps and dip-
per switch to the "
" or "
5-46
Instruments and controls
NOTE
• Put the operation mode of the power switch
in ON.
It is possible to modify functions as follows:
• The time that the headlamps remain on can
be changed.
• The coming home light function can be
deactivated.
For further information, please contact an
authorised MITSUBISHI MOTORS dealer.
Turn-signal lever
The turn-signal lamps flash when the lever is
operated (with the operation mode of the
power switch in ON). At the same time, the
turn-signal indicator flashes.
" position.
1- Turn-signals
When making a normal turn, use posi-
tion (1). The lever will return automati-
E00506503440
cally when cornering is completed.
2- Lane-change signals
When moving the lever to (2) slightly
to change a lane, the turn-signal lamps
and indicator lamp in the instrument
cluster will only flash while the lever is
operated.
Also, when you move the lever to (2)
slightly then release it, the turn-signal
lamps and indicator lamp in the instru-
ment cluster will flash 3 times.
NOTE
If the lamp flashes unusually quickly, the
bulb in a turn-signal lamp may have burned
out. Have the vehicle inspected by an author-
ised MITSUBISHI MOTORS dealer.
Advertisement
Chapters
Table of Contents
