Environmental Specifications - FATEK M Series User Manual

1. Turn off all power during installation of M Series PLC or related equipment to prevent electric shock
or damage to equipment.
2. During installation, never remove the dust cover sheet that were surrounded the PLC before wiring
is completed to avoid complications such as fire hazards, breakdown, or malfunction caused by drill
dust or wire shreds falling inside PLC.
3. Upon completion of installation and wiring, remember to remove the dust cover sheet to avoid fire,
breakdown or malfunction, caused by overheating.

3-1 Environmental Specifications

1. Environmental specifications of M Series PLC cannot exceed those listed in this manual. In addition, do not
operate this equipment in environments with oil smoke, conductive dust, high temperatures, high humidity,
corrosion gases, inflammable gases, rain or condensation, and high vibrations and shock.
2. This product has to be housed appropriately whether it's used in a system or standalone. The choice and
installation of housing must comply with local national standards.
Environmental Specifications Table
Item
Operating Ambient
Temperature
Storage Temperature
Relative Humidity
(non-condensing, RH-2)
Pollution Level
Altitude
Vibration Resistance
(Fixed by DIN RAIL)
Shockproof
Noise Suppression
Withstand Voltage
The listed environmental specifications are for M Series PLC under normal operation. Any operation in
environment not conform to above conditions should be consulted with FATEK.
Danger
⚠Caution
Specification
0~55℃
-25 ~ +70℃
5 ~ 95%
Dergree Ⅱ
≦2000m
5~8.4Hz Amplitude: 3.5
8.4~150Hz Constant acceleration:19.6m/s^2(2G)
10G, 10 times each along the 3 axes (IEC61131-2
Standard)
10G, 3 times each along the 3 axes
1500Vp-p, Width: 1us
1500 VAC 1 minute (Between power terminals and
input/output terminals, and between all external
terminals and the housing)
Warning
Chapter 3 Installation and Wiring
2
M-Series PLC Expansion Module User Manual
note
Permanent Installation