FATEK M Series User Manual page 31

3-2-3 Fixation by DIN RAIL
In an environment with slight vibration (less than 0.5G), this is the most convenient way of fixation and
is easy for maintenance. Please use DIN EN50022 DIN RAIL, as shown in the figure below.
Mount
Hold PLC facing its front, press it down with a 15-degree tilt onto the DIN RAIL. Swing it down until
the upper edge of DIN RAIL groove on PLC back touches the upper tab of DIN RAIL. Then use this locked-
in point as a pivot to press the PLC forward on the bottom and lock it in position. The procedure is illustrated
below.
Dismount
Use a long screwdriver to reach in the hole on the DIN RAIL tab. Pull out the tab to "pulled out"
position to remove PLC, as shown in the figure below.
DIN RAIL SIZE
Mount DIN RAIL
Dismount DIN RAIL
5
M-Series PLC Expansion Module User Manual
Chapter 3 Installation and Wiring