Beeper Code Information - BRP SeaDoo GTI PRO 130 Operator's Manual

MONITORING SYSTEM

Beeper Code Information

BEEPER CODES
1 long beep
(when installing tether
cord on engine cut-off
switch)
A 2 second beep
every 15 minute interval
A 2 second beep
every 5 minute interval
______________
118
Bad D.E.S.S. system connection.
Reinstall tether cord correctly on engine cut-off switcht.
Wrong D.E.S.S. key.
Use a tether cord that has been programmed for the
watercraft.
Defective D.E.S.S. key.
Use another programmed tether cord.
Dried salt water in tether cord cap.
Clean tether cord cap to remove salt water.
Defective engine cut-off switch.
Refer to an authorized Sea-Doo dealer.
Improper operation of ECM or defective wiring
harness.
Seek service from an authorized Sea-Doo dealer, repair
shop, or person of your own choosing for maintenance,
repair, or replacement. Please refer to the
EMISSION-RELATED WARRANTY
information about warranty claims.
Watercraft is upside down.
Turn watercraft upright. Refer to
Engine management system fault.
Seek service from an authorized Sea-Doo dealer, repair
shop, or person of your own choosing for maintenance,
repair, or replacement. Please refer to the
EMISSION-RELATED WARRANTY
information about warranty claims.
iBR system fault.
Refer to an authorized Sea-Doo dealer.
Low fuel level.
Refill fuel tank. If problem persists, refer to an authorized
Sea-Doo dealer.
Fuel tank level sensor or circuit malfunction.
Refer to an authorized Sea-Doo dealer.
DESCRIPTION
contained herein for
SPECIAL PROCEDURES
contained herein for
US EPA
.
US EPA