Exhaust System - BRP SeaDoo GTI PRO 130 Operator's Manual

MAINTENANCE PROCEDURES
smr2014-032-051_a
1. Ignition coil
2. Spark plug
Spark Plug Installation
Prior to installation, ensure the contact
surfaces of the cylinder head and spark
plug are free of grime.
1. Using a wire feeler gauge, check
electrode gap as specified in
NICAL SPECIFICATIONS
2. Apply LOCTITE 767 (ANTISEIZE LU-
BRICANT) (P/N 293 800 070) over
the spark plug threads to prevent
possible seizure.
3. Hand screw spark plug into cylinder
head. Then, tighten the spark plug
to specification with an approved
spark plug socket.
TIGHTENING TORQUE
Spark plug
4. Install ignition coil. Refer to
TION COIL INSTALLATION
5. Close seat.

Exhaust System

Exhaust System Flushing
Flushing the exhaust system with
fresh water is essential to neutralize
corroding effects of salt or other chem-
ical products present in water. It will
help to remove sand, salt, shells or
other particles in water jackets and/or
hoses.
______________
92
TECH-
.
17 N•m ± 1 N•m
(150 lbf•in ± 9 lbf•in)
.
Flushing should be performed when
the watercraft is not expected to be
used further the same day or when the
watercraft is stored for any extended
time.
NOTE: Repeat the flushing procedure
on the starboard side of the stern when
vehicle was used in water where there
were long debris such as plants, algae,
and seaweed.
Perform this operation in a well
ventilated area.
Proceed as follows:
Clean propulsion system by spraying
water in its inlet and outlet and then
apply a coating of XPS Lube or equiva-
lent.
CAUTION When operating the
engine while the watercraft is out
of the water, the heat exchanger in
the ride plate may become very hot.
Avoid any contact with ride plate as
burns may occur.
Connect a garden hose to the connec-
tor located at the rear of watercraft (on
the port side of the stern). Do not open
water tap at this time.
NOTICE
IGNI-
before opening the water tap. If not,
water will get inside the engine.
219001838-023_a
TYPICAL
1. Flushing connector location
WARNING
Always run the engine