What To Do After Launching The Watercraft - BRP SeaDoo GTI PRO 130 Operator's Manual

WARNING
Check handlebar and correspond-
ing steering nozzle operation be-
fore starting. Never turn handle-
bar while someone is near the rear
of the watercraft. Keep away from
steering moving parts (nozzle, iBR
gate, linkages etc.).
Throttle Lever
Check the Electronic Throttle Control
lever (ETC) for free and smooth opera-
tion. It should return to its initial posi-
tion immediately after it is released.
WARNING
Check throttle lever operation be-
fore starting the engine. If any fric-
tion is felt in the throttle lever, refer
to an authorized Sea-Doo dealer.
iBR Lever (if equipped)
Check the iBR lever for free and
smooth operation. It should return
to its initial position immediately after
it is released.
WARNING
Check iBR lever operation before
starting the engine. If any friction
is felt in the iBR lever, refer to an
authorized Sea-Doo dealer.
Storage Compartment, Glove Box
and Seat
Ensure all required safety and survival
equipment and any additional cargo is
properly stored in the storage compart-
ment provided.
Ensure the front cover, glove box, and
seat are closed and latched.
WARNING
Ensure the seat, glove box, and
front storage compartment cover
are securely latched.
________
SAFETY INFORMATION
Engine Cut-Off Switch and Engine
START/STOP Button
Press the start button once without in-
stalling the tether cord cap on the en-
gine cut-off switch.
Install the tether cord cap on the en-
gine cut-off switch.
Press the START/STOP button to start
the engine, then stop it by pressing the
START/STOP button a second time.
NOTE: To allow engine starting, the
tether cord cap must be properly in-
stalled on the engine cut-off switch
within 5 seconds of pressing the
START/STOP button.
Restart the engine, then stop it by re-
moving the tether cord from the engine
cut-off switch.
WARNING
Should the tether cord cap be
loose or fail to remain on the en-
gine cut-off switch, replace the
tether cord immediately in order
to avoid unsafe use. If remov-
ing the tether cord cap from the
engine cut-off switch or pressing
the START/STOP button does not
stop the engine, do not use the
watercraft. See your authorized
Sea-Doo dealer.
What to Do After
Launching the Watercraft
Check the items listed in the follow-
ing table after launching the watercraft
and before going for a ride.
ITEM
Information
Center
Intelligent Brake
and Reverse
System (iBR)
Variable Trim
System (VTS)
(as applicable)
________
PRE-RIDE INSPECTION
OPERATION
Check operation
Check operation
Check operation
✓
41