Beeper Code Information - BRP GTX Series Operator's Manual

Personal watercraft
Hide thumbs Also See for GTX Series:
Table of Contents

Advertisement

PILOT
LAMPS (ON)
-
-
-
-
NOTICE
Running engine with low oil pressure may severely damage the
engine.

Beeper Code Information

BEEPER CODES
1 Long Beep
(while installing DESS
key on watercraft post)
1 Short Beep
followed by 1 long beep
4 Short Beeps
at different interval for
4 hours
A 2 Seconds Beep
every 15 minutes interval
MESSAGE DISPLAY
OIL
MAINTENANCE
SUPERCHARGER
SENSOR
KEY
L KEY
Bad DESS system connection.
Reinstall DESS key correctly over post.
Wrong DESS key.
Use a DESS key that has been programmed for the
watercraft.
Defective DESS key.
Use another programmed DESS key.
Dried salt water in DESS key.
Clean DESS key to remove salt water.
Defective DESS post.
Refer to an authorized Sea-Doo dealer.
Improper operation of ECM or defective wiring
harness.
Refer to an authorized Sea-Doo dealer.
ECM has been mistakenly set to onboard diagnostic
mode.
Remove and reinstall DESS key.
DESS key has been left on its post without starting
engine or after engine was stopped.
To prevent battery discharge, remove the DESS key from
its post.
Watercraft is upside down.
Turn watercraft upright. Refer to
Engine management system fault.
Refer to an authorized Sea-Doo dealer.
Low oil pressure
Maintenance on supercharger required
Sensor failure (vehicle electronic equipment)
Invalid DESS key
DESS learning key active
DESCRIPTION
______________
MONITORING SYSTEM
DESCRIPTION
SPECIAL PROCEDURES
.
119

Advertisement

Table of Contents
loading

Table of Contents