Pre-Ride Inspection; What To Do Before Launching The Watercraft - BRP SeaDoo GTI PRO 130 Operator's Manual

PRE-RIDE INSPECTION

We encourage you to have an Annual Safety Inspection of your vehicle. Please
contact an authorized BRP dealer for further details. Though not required, it is
recommended that an authorized BRP dealer performs the preseason preparation
of your vehicle. Each visit to your authorized BRP dealer is a great opportunity for
your dealer to verify if your vehicle is included in any safety campaign. We also
urge you to visit your authorized BRP dealer in a timely manner if you become
aware of any safety related campaigns.
Perform a pre-ride inspection before each ride to detect potential problems
during operation. The pre-ride inspection can help you monitor wear and
deterioration before they become a problem. Correct any problems that
you discover to reduce the risk of a breakdown or crash.
Before performing the pre-ride inspection, read and understand the
section.

What to Do Before Launching the Watercraft

Engine should be off and the tether cord cap should always be removed
from the engine cut-off switch prior to verifying any of the following points.
Only start watercraft once all items have been checked and operate prop-
erly.
NOTE: Before starting the engine and taking off, it is recommended to shake verti-
cally the rear of the watercraft to shake away any sand that may have accumulated
near the propulsion and reverse systems.
Check the items listed in the following table before launching the watercraft.
ITEM
Hull
Jet pump water intake
Drain plugs
Fuel tank
Engine compartment
Engine oil level
Engine coolant level
Steering system
_______
38
WARNING
WARNING
Inspect hull, ride plate and water inlet
grate for damages
Inspect/clean
Tighten.
Refill.
Check for any visible fluid leaks and
gasoline vapor odor.
Check/refill.
Check/refill.
Check operation.
SAFETY INFORMATION
OPERATION
________
CONTROLS
✓