Ignition Coils; Spark Plugs - BRP SeaDoo GTI PRO 130 Operator's Manual

Add coolant, see
ENGINE COOLANT
to adjust coolant level between marks
as required. Use a funnel to avoid
spillage. Do not overfill.
Properly reinstall and tighten filler cap,
then reinstall ventilation box and close
seat.
NOTE: A cooling system that fre-
quently requires coolant is an indica-
tion of leaks or engine problems. See
an authorized Sea-Doo dealer.
Engine Coolant Replacement
Coolant replacement should be per-
formed by an authorized Sea-Doo
dealer.

Ignition Coils

Ignition Coil Removal
1. Open seat.
2. Disconnect ignition coil connector.
3. Remove ignition
screw.
NOTICE
Do not pry on ignition coil
with a tool.
4. Remove ignition coil from spark plug
by rotating coil side to side as you
pull up.
Ignition Coil Installation
Install the ignition coil on the spark
plug.
Align the retaining screw hole of the ig-
nition coil with the threaded hole on the
valve cover.
Push the ignition coil all the way down
until it rests on the valve cover.
Install and tighten retaining screw.
IGNITION COIL RETAINING SCREW
Tightening
torque
Connect ignition coil connector.
RECOMMENDED
for specification,
coil retaining
9 N•m ± 1 N•m
(80 lbf•in ± 9 lbf•in)

Spark Plugs

Spark Plug Removal
1. Open seat.
2. Disconnect the ignition coil input
connector.
3. Remove ignition coil. Refer to
TION COIL REMOVAL
Never remove an ignition coil from
a spark plug without disconnect-
ing it from the wiring harness.
Flammable vapors may be present
in the bilge. Should the tether cord
be installed on the engine cut-off
switch, a spark could be generated
at the spark plug end of the coil
possibly resulting in an explosion.
4. Using a spark plug socket, release
the torque applied to the spark plug.
1
A00E0BA
1. Approved socket
2. Improper socket
5. Clean the spark plug and cylinder
head with pressurized air.
6. Unscrew spark plug then use the
ignition coil to take spark plug out of
spark plug hole.
_______________
MAINTENANCE PROCEDURES
.
WARNING
IGNI-
2
91