Operating Instructions; Boarding The Watercraft - BRP SeaDoo GTI PRO 130 Operator's Manual

OPERATING INSTRUCTIONS

WARNING
Always perform the
SPECTION
before operating this
watercraft. Be sure to read the
SAFETY INFORMATION
WATERCRAFT INFORMATION
tions and be thoroughly familiar
with the iControl technology.
Should any control or instruction not be
fully understood, refer to an authorized
Sea-Doo dealer.

Boarding the Watercraft

As with any watercraft, boarding
should be done carefully and engine
must not be running.
Make sure to practice each boarding
methods until fully able to safely board
in any potential condition.
WARNING
Engine must be OFF and tether
cord must be removed when
boarding the watercraft or when
using the boarding ladder.
Boarding from a Dock
When boarding from a dock, slowly
place one foot on the watercraft foot-
board nearest the dock while holding
the handlebar, and at the same time,
transfer the body weight to the other
side in order to balance the watercraft.
Then bring the other foot over the seat
and place it on the other footboard.
Push the watercraft away from the
dock.
PRE-RIDE IN-
and the
sec-
_______________
F18A01Y
Boarding from Water
WARNING
– Keep limbs away from jet or in-
take grate.
– Never use propulsion system as
a supporting point to board the
watercraft.
Ensure there is at least 90 cm (3 ft) of
water underneath the lowest rear por-
tion of the hull.
Take into account that the hull will be
lower in the water when all passen-
gers are aboard. Be certain to maintain
the specified depth so sand, pebbles
and rocks will not be drawn up in the
propulsion system.
F18L0XY
A. Maintain at least 90 cm (3 ft) underneath
the lowest rear portion of the hull when all
passengers are aboard
A
63