Information Center Setup; Unlock Is Suspension; Ending A B.u.d.s. Session - BRP SEA-DOO GTX LTD iS 255 Predelivery Bulletin

Click the Write Data button.
vmr2006-012-100_ben
After the write operation, remove key from
D.E.S.S. post.
Try the key(s) on the watercraft.
Setting Maximum Speed for Learning and
Rental Keys
To change Learning or Rental Key settings, refer
to the OPERATOR'S GUIDE

Information Center Setup

Briefly press start/stop button to power the ECM.
Engine must not crank.
Press the start/stop button every three
NOTE:
minutes or the electrical system will shut off.
Select the Read Data button.
Choose the Setting tab at the top of the page.
At the bottom LH side of the setting page, select
the Cluster tab.
smr2009-036-001_a
1. Read Data
2. Setting tab
3. Cluster tab
In the Cluster Language field, choose the desired
unit of language, English, French or Spanish.
In the Cluster Units field, choose the desired unit
of measurement, Imperial or Metric.
PREDELIVERY
.
smr2008-028-002_a
1. Cluster Language field
2. Cluster Units field

Unlock iS Suspension

The iS suspension is locked in B.U.D.S. and will
not move until you click on the UNLOCK iS but-
ton.
sbl2009-004-055_a
ACTIVATION AND IBR TABS
1. UNLOCK iS button

Ending a B.U.D.S. Session

Before ending the B.U.D.S. session, you need to
clear the maintenance reminder indicators.
Choose the Vehicle tab at the top of the page.
At the bottom RH side of the vehicle page
in the Last Service field, choose Reset Ser-
vice/"Maint" button.
2009-3
B.U.D.S. PROGRAMMING
19 / 23