Engine Cut-Off Switch - BRP SeaDoo GTI PRO 130 Operator's Manual

NOTE: If the START/STOP button is
pressed and held without the tether
cord installed, the information cen-
ter displays will stay on as long as the
START/STOP button is held.

3) Engine Cut-Off Switch

The engine cut-off switch is located in
the middle of the handlebar.
smo2011-003-018_b
TYPICAL
1. Engine cut-off switch
To allow engine starting, the tether
cord cap must be securely snapped
onto the engine cut-off switch.
WARNING
Always attach the tether cord clip
to the operator's personal flota-
tion device (PFD) or wrist (wrist
strap required).
smo2009-002-115_a
TYPICAL
1. Tether cord cap on the engine cut-off switch
2. Tether cord clip secured to operator's PFD
To stop engine, pull the tether cord cap
from the engine cut-off switch.
Should the engine be stopped, the
brake function (models with iBR)
and watercraft directional control
is lost.
Always disconnect the tether cord
when the watercraft is not in oper-
ation in order to prevent accidental
engine starting or to avoid unau-
thorized use by others, children,
and to prevent theft.
Digitally Encoded Security System
(D.E.S.S.)
The tether cord cap contains a D.E.S.S.
key that is programmed to give it a
unique electronic serial number. This
is the equivalent of a conventional key.
The D.E.S.S. system reads the key
in the tether cord cap that is installed
on the engine cut-off switch, and only
allows engine starting for keys it rec-
ognizes.
The D.E.S.S. system brings great flex-
ibility. You can buy additional tether
cords and have the D.E.S.S. keys pro-
grammed to your watercraft.
A total of ten D.E.S.S. keys can be pro-
grammed to the same watercraft.
To have a key programmed to your
watercraft, see your authorized BRP
Sea-Doo dealer.
D.E.S.S. Key Types (If Applicable) or
RF D.E.S.S. key types (If Applicable)
Two types of keys can be used:
– Normal key
– Learning key
To ease key type recognition, the
tether cord float comes in different
colors.
_______________
CONTROLS
WARNING
WARNING
45