Capsized Watercraft - BRP SeaDoo GTI PRO 130 Operator's Manual

SPECIAL PROCEDURES
6. Release the LH lever to exit override
mode.
7. Remove tether cord from vehicle
before working near iBR gate.
WARNING
If it is necessary to reach in to re-
move any foreign object caught
in the propulsion system, strictly
observe the following before pro-
ceeding:
– Remove tether cord from the
engine cut-off switch.
– Wait at least 5 minutes.
– Do not press on START/STOP
button. Should the START/
STOP button be pressed, wait
another 5 minutes.
Deactivating iBR Override Function
To deactivate the iBR override func-
tion, release the iBR lever. The IBR
OVERRIDE ON- RELEASE LEVER TO
EXIT message will cease to scroll in
the multifunction gauge.
NOTE: When the engine is started,
the iBR gate will move to the neutral
position.
WARNING
When moving the iBR gate using
the iBR override function, ensure
no-one stands near the rear of the
watercraft. Movement of the gate
may squeeze fingers.

Capsized Watercraft

NOTE: Some vehicle safety labels are
not shown on illustrations. For infor-
mation on vehicle safety labels, refer
WATERCRAFT SAFETY LABELS
to
The watercraft is designed so that it
should not turn over easily. Two spon-
sons mounted on the side of the hull
assist watercraft stability. If it turns
over, it will remain capsized.
______________
82
When watercraft is capsized, do
not attempt to restart the engine.
Operator and passengers should
always wear approved personal
flotation devices.
To turn the watercraft upright, ensure
the engine is off and the tether cord
is NOT on the engine cut-off switch.
Then grab the inlet grate, step on a
side bumper rail, and use your weight
to rotate the watercraft towards you.
NOTE: A label on the stern near the
flushing connector provides instruc-
tions on how to turn the watercraft
right side up. The label is upside down
so that it can be read when the water-
craft is overturned.
smo2009-002-153_a
The 4-TEC™ engine features a tip-over
protection system (T.O.P.S.
the watercraft tips over, the engine is
automatically stopped.
When the watercraft is returned to its
normal operating position, the engine
can be started normally.
NOTICE
.
capsized for more than 5 minutes,
do not attempt to crank the engine
to avoid water ingestion that would
damage the engine. See an autho-
rized Sea-Doo dealer as soon as pos-
sible.
WARNING
If the watercraft has been
TM ). When