External Connections - Titan PULSITE LINK Instruction Manual

5.4.2 External Connections

Within this section the user can configure pulse, analog and alarm outputs.
© Titan Enterprises Ltd 2023
®
Rate (units per): This is the time base for the flow rate and
has the option of Second, Minute or Hour
Scale Factor Adjustment: This allows the user to adjust or
tune the calibration flow value if required.
Density: The flowmeter is fundamentally a volumetric device,
but a density figure can be entered here if one of the mass
units is selected. Caution must be used however, as there is
no temperature/density correction.
Cut Off: Flow values below this level will be set to zero.
www.flowmeters.co.uk
.
Pulsite®Link_Instruction_Manual_0823
20