Table of Contents
Advertisement
1. 9. 3. AC Power Connection
The supplied AC Power Cord is used to power the RSO Rheometer.
Always connect the power cord to a properly grounded socket. To avoid electric shock or damage
to system components, always use a properly grounded plug to connect the power cord.
Be sure to observe the following instructions:
•
Always inspect the Power Cord for defects/damage before plugging it into an outlet.
•
Never use a damaged Power Cord. If necessary, contact AMETEK Brookfield or the au-
thorized dealer from whom you purchased the instrument for a replacement Power Cord.
•
The Power Cord should always lay flat and uncovered.
•
Position cables and Power Cord in a way to ensure that no one will stumble over them.
•
The Power Cord and the cables must never be in contact with liquids.
Connecting the AC Power Cord:
•
Insert the female end of the Power Cord into the AC Power In socket on the back of the RSO Rheometer.
•
Plug the Power Cord into a grounded AC outlet.
The AC input voltage and frequency must be within the appropriate range.
See section X.1 Power Supply
1. 9. 4. Remove Foam Shipping Block
To remove the Foam Shipping Block, turn on the device. See section IV.3 Power Up. It is not
necessary to have compressed air available. As soon as the RSO Rheometer starts to lift its
head, the foam block can be removed. See figures.
M19-230-REV.B
© 2020 AMETEK Brookfield Inc. All rights reserved.
Page 15
Advertisement
Table of Contents
