My Software Isn't Recognizing My Modem - US Robotics USR5610B User Manual

14 C 4: T H R
HAPTER ROUB LESHOOTING A ND ELP ESOU RCES
Windows NT Click Windows Start, Settings, and then Control
Panel. Double-click Ports. Make sure the port you are plugging the
modem into appears in the list. If it does not, the port needs to be added,
and possibly enabled in the BIOS. Consult your Windows NT manual for
information about adding ports. After you add or enable the port, follow
the instructions on the front of the Installation Guide that came with your
modem to install your modem.
My software isn't Possible solution:
recognizing my
Your communications software may not function properly if you have
modem.
more than one version of the software installed, you are using an older
version, or you have more than one communications software installed
on your system. We highly recommend using the communications
software provided with your modem on the Installation CD-ROM.
Possible solution:
Make sure the modem is plugged in and turned on. If it is, check the
outlet with another electric device (like a lamp) to be sure that you are
getting power. Also, you must use the power supply that came with your
modem; other similar-looking power supplies may be of different
voltages and could damage your modem. When your modem is properly
connected to power and is turned on, the CS light on the front panel will
be on.
Possible solution:
Your software's port settings may be incorrect. Make sure the software's
port settings match those for your modem. This information is on the
Installation Guide that came with your modem. There should be a place
in the Setup section of your software for this.
Possible solution:
Windows 2000 You may not have the correct modem type selected in
your software or in Windows. Click on Windows Start, Settings, and
Control Panel. When Control Panel opens, click Phone and Modem
Options. Click the Modems tab. Here you will see a list of installed
modems. You can also add, remove, or view the properties of modems
from this window. The U.S. Robotics modem you have installed should be
present in the list of installed modems. If none of the modem descriptions
in the list matches your U.S. Robotics modem or no modems are listed,