HOW TO RIDE THE MOTORCYCLE
88
Stopping the Engine
The
engine
stopped by turning the ignition switch
to the OFF position.
The
engine
emergency use only.
Do not leave the ignition switched on
with the engine stopped. Electrical
damage may result.
0
MPH
N
1
RPM X 1000
0
10
1.
Neutral indicator light
2.
Engine stop switch - STOP position
3.
Master ignition switch - OFF position
(if equipped)
To stop the engine:
Close the throttle completely.
▼
Select neutral.
▼
Place the engine stop switch in the
▼
STOP position.
Turn the master ignition switch to
▼
the OFF position (if equipped).
Select first gear.
▼
Support the motorcycle on a firm,
▼
level surface with the side stand.
Lock the steering.
▼
Do not leave the ignition switched
on with the engine stopped. This will
cause electrical damage.
Caution
should
normally
stop
switch
is
3
2
Caution
Starting the Engine
be
Never start the engine or run the
engine in a confined area.
Exhaust fumes are poisonous and can
for
cause loss of consciousness and death
within a short period of time.
Always operate the motorcycle in the
open air or in an area with adequate
ventilation.
Do
not
continuously
seconds as the starter motor will
overheat and the battery will become
discharged.
Wait
15 seconds
operation of the starter to allow for
cooling and recovery of battery power.
Do
not
long periods as this may lead to
overheating which will cause damage
to the engine.
Warning
Caution
operate
the
for
more
than
between
let
the
engine
starter
five
each
idle
for