Table of Contents
Advertisement
MAINTENANCE
128
To adjust the front brake fluid level:
Loosen the reservoir cap retaining
▼
screws and remove the reservoir
cap and the diaphragm seal.
Fill the reservoir to the MAX level
▼
line using new DOT 4 brake fluid
from a sealed container.
Install the diaphragm seal into the
▼
reservoir cap and make sure that
the holes for the fasteners in the
reservoir cap and the diaphragm
seal are correctly aligned.
1
3
1.
Reservoir cap
2.
Diaphragm seal
3.
Reservoir cap retaining screw holes
Install the reservoir cap retaining
▼
screws into the reservoir cap and
diaphragm seal assembly.
Hold
▼
and position the reservoir cap,
diaphragm seal and reservoir cap
retaining screws onto the reservoir.
1
1.
Reservoir cap, diaphragm seal and
reservoir cap retaining screws assembly
2
2.
Reservoir
3
Tighten the reservoir cap retaining
▼
screws to 9 lbf in (1 Nm).
If the reservoir cap retaining screws
are over tightened this can result in a
brake fluid leak.
A dangerous riding condition leading
to loss of motorcycle control and an
accident could result if this warning is
ignored.
the
assembly
2
Warning
together
Advertisement
Chapters
Table of Contents
