Table of Contents
Advertisement
Traction Control (TC) Indicator Light
The
Traction
indicator light is used to
indicate
control system is active and is
working to limit rear wheel slip during
periods of hard acceleration or under
wet or slippery road conditions. Traction
control will not function if there is a
malfunction with the ABS. The warning
lights for the ABS, traction control and
the MIL will be illuminated.
Warning
If
the
traction
functioning, care must be taken when
accelerating and cornering on wet/
slippery road surfaces to avoid rear
wheel spin.
Do not continue to ride for longer
than is necessary with the engine
management
system
Indicator Light (MIL) and traction
control
warning
Contact an authorized Triumph dealer
as soon as possible to have the fault
checked.
Hard acceleration and cornering in this
situation may cause the rear wheel
to spin resulting in loss of motorcycle
control and an accident.
If traction control is switched on:
Under normal riding conditions the
▼
TC indicator light will remain off.
The TC indicator light will flash
▼
rapidly when the traction control
system is working to limit rear
wheel slip during periods of hard
acceleration
or
slippery road conditions.
Control
(TC)
that
the
traction
control
is
not
Malfunction
lights
illuminated.
under
wet
or
GENERAL INFORMATION
If traction control is switched off:
The TC indicator light will not
▼
illuminate. Instead the TC disabled
warning light will be illuminated.
Traction Control (TC) Disabled
Warning Light
The TC disabled warning light
should not illuminate unless
traction control is switched
off or there is a malfunction.
If
the
warning
illuminated while riding, it indicates
that the traction control system has a
malfunction that requires investigation.
Turn Signals
When the turn signal switch is
turned to the left or right, the
indicator warning light will
flash on and off at the same
speed as the turn signals.
Hazard Warning Lights
To turn the hazard warning lights on
or off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched OFF, until the
hazard warning light switch is pressed
again.
High Beam Light
When the high beam button is
pressed the high beam will be
switched on. Each press of
the button will swap between
dip and high beam.
light
becomes
31
Advertisement
Chapters
Table of Contents
