Basic Transmission Method - Konica Minolta bizhub 266 User Manual

6.1

Basic transmission method

6 How to Use Scan to Server
This chapter describes how to transmit scanned data to the server.
Tips
To select the destination using the Speed dial, Extended Operation Panel MK-750 must be installed.
6.1 Basic transmission method
This section describes the basic transmission method.
Tips
-
To run Scan to Server (FTP/SMB), the FTP/SMB server address has to be registered as a speed dial
number in advance.
-
When uploading scanned data onto the server, the user can set whether an E-mail is sent to notify of
successful data unloading. This machine can register ten E-mail addresses.
To inform the other party via E-mail, SMTP server has to be registered in advance.
-
To register a server or to set up E-mail notification, access to Web Connection has to be set up in the
administrator mode. These settings cannot be made through the Control Panel.
d
Reference
For details on accessing Web Connection in Administrator mode, refer to Web Connection in [User's Guide
Network Administrator].
For details on registration of the FTP/SMB server address to the speed dial number and setting of information
by E-mail, refer to Web Connection - [Address] tab - [Speed Dial Setting] in [User's Guide Network Admin-
istrator].
For details on setting SMTP server, refer to Web Connection - [Network] tab - [SMTP & POP3 Configuration]
in [User's Guide Network Administrator].
bizhub 306/266
6
6-3