Table of Contents
Advertisement
LED-SIGNAL
Presence
detection
LED flashes
x
INSTALLATION
The sensor should be
fixed firmly to avoid
extreme vibrations.
MAINTENANCE
It is recommended to clean the
optical parts at least once a
year or more if required due to
environmental conditions.
SAFETY
The door control unit
and the door cover
profile must be correctly
earthed.
•
The sensor cannot be used for purposes other than its intended use.
•
The manufacturer of the door system incorporating the sensor is responsible for compliance of the system
to applicable national and international regulations and safety standards.
•
The installer must read, understand and follow the instructions given in this manual. Improper installation
can result in improper sensor operation.
•
The manufacturer of the sensor cannot be held responsible for injury or damage resulting from incorrect
use, installation or inappropriate adjustment of the sensor.
LED flashes
LED flashes
red-green
x times
Do not cover the sensor.
For complete cleaning, remove
both windows by inserting a
screwdriver into the notches
located between the two
windows.
Only trained and
qualified personnel
may install and setup
the sensor.
LED flashes
quickly
Avoid moving objects
and light sources in
the detection field.
Do not use aggressive
products to clean
the optical parts.
Always test the good
functioning of the
installation before
leaving the premises.
LED is off
Avoid highly
reflective objects in
the infrared field.
The warranty is invalid if
unauthorized repairs are
made or attempted by
unauthorized personnel.
7
Advertisement
Table of Contents
