Table of Contents
Advertisement
2 Specifi cations (Continued)
DESCRIPTION
Detection mode:
Angle:
Output specifi cation:
Output hold-time
Manual adjustment:
Remote control adjustments
3 Precautions
Shut off all power going to header before attempting any wiring procedures.
Maintain a clean & safe environment when working in public areas.
Constantly be aware of pedestrian traffi c around the door area.
Always stop pedestrian traffi c through the doorway when performing tests that may result in unexpected reactions by the
door.
ESD electrostatic discharge: Circuit boards are vulnerable to damage by electrostatic discharge. Before handling any board
ensure you dissipate your body's charge.
Always check placement of all wiring before powering up to insure that moving door parts will not catch any wires and cause
damage to equipment.
Ensure compliance with all applicable safety standards (i.e. ANSI A156.10) upon completion of installation.
DO NOT attempt any internal repair of the sensor. All repairs and/or component replacements must be performed by BEA,
Inc. Unauthorized disassembly or repair:
1. May jeopardize personal safety and may expose one to the risk of electrical shock.
2. May adversely affect the safe and reliable performance of the product will result in a voided product warranty.
4 Pre Installation Check
1.
When preparing to wire multiple devices together for a "system" confi guration, it is best to ensure the correct operation of each device inde-
pendently before starting to help reduce troubleshooting time later in the event of a discrepancy.
2.
Prior to installing any equipment, ensure the correct line voltage and stability. When applying equipment on a new installation utilizing new
electrical supply circuits, always ensure that correct line voltage exists and is stable. Remember to shut the power back off after this is
checked and before performing any wiring to the system.
5 Installation
1
Remove Sensor Cover
1. Remove cover from unit by gently prying the tab on the backside of
the sensor housing or if the sensor is installed on the header insert
a screwdriver behind the unit and gently pry off the cover.
Page 2 of 13
MOTION SENSOR
Minimum detection speed
2 inches / sec. (measured in the sensor axis)
From 15° to 50° in elevation (adjustable)
Relay (free of potential change-over contact):
• Max contact voltage: 42V AC/DC
• Max contact current: 1A (resistive)
• Max switching power: 30W (DC) / 60VA (AC)
0.5s to 9s (adjustable)
• orientation of sensing fi eld (mechanically)
• shape of the sensing fi eld (choice of antenna)
• multiple functions (using push buttons)
• Sensitivity
• Hold time
• Detection mode
• Immunity
• Output confi guration
PRESENCE SENSOR
Response time: < 128ms
From - 4° to + 4° (adjustable)
Transistor (optocoupled transistor)
• Max output current: 100 mA
• Max switching power: 48 VDC
1s (fi xed)
• orientation of sensing fi eld
• shape of the sensing fi eld (choice of front lens)
• multiple functions (by push buttons)
• Sensitivity
• Auto-learn time
• Monitoring mode
• Number of Curtains
• Relay / Transistor confi guration
• Rain Mode
• Snow Mode
Tab
Pry
75.5122.05 20070427
Advertisement
Table of Contents
