Analog Devices Lite ADSP-21371 EZ-KIT System Manual page 23

Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Step 1: Connect the EZ-KIT Lite board to a personal computer (PC) run-
ning CCES using one of two options: an Analog Devices emulator or via
the debug agent.
Using an Emulator:
1. Plug one side of the USB cable into the USB connector of the emu-
lator. Plug the other side into a USB port of the PC running
CCES.
2. Attach the emulator to the header connector
the EZ-KIT Lite board.
Using the on-board Debug Agent:
1. Plug one side of the USB cable into the USB connector of the
debug agent
ZJ1
2. Plug the other side of the cable into a USB port of the PC running
CCES.
Step 2: Attach the provided cord and appropriate plug to the 7V power
adaptor.
1. Plug the jack-end of the power adaptor into the power connector
on the EZ-KIT Lite board.
J4
2. Plug the other side of the power adaptor into a power outlet. The
power LED (labeled
board.
3. Power the emulator (if used). Plug the jack-end of the assembled
power adaptor into the emulator and plug the other side of the
power adaptor into a power outlet. The enable/power indicator is
lit green when power is applied.
ADSP-21371 EZ-KIT Lite Evaluation System Manual
Using the ADSP-21371 EZ-KIT Lite
(labeled ).
USB
) is lit green when power is applied to the
LED9
(labeled ) on
ZP4 JTAG
1-5