Frost Protection Mode; Sleep Mode - Salus RT310RF Full User Manual

5.2 Frost protection mode

In this mode the setpoint temperature is automatically set to frost setpoint to prevent pipes from freezing. If the room temperature is lower than the frost
setpoint, frost protection will be enabled. To set frost protection mode follow steps below:
1
The Frostpoint temperature can be reviewed by pressing the UP button once, but can only be changed in Installer Mode. Frost protection mode
can be enabled only in HEAT mode.

5.3 Sleep mode

In sleep mode thermostat is switched off and doesn't consume any energy and it is impossible to make an action until you activate the thermostat again.
To activate/deactivate sleep mode follow steps below:
TO ACTIVATE SLEEP MODE:
1
Press and hold
simultanously to turn ON sleep mode.
TO DEACTIVATE SLEEP MODE:
1
To deactivate sleep mode press any
Press button to turn
ON/OFF frost protection.
3 sec
3 sec
+ buttons
button.
2
Snowflake icon will be displayed if
frost protection is active.
2
In sleep mode thermostat's
display is blank.
2
Thermostat will go back to work and
display main screen.
15