Operation - Crestron PROCISE PROAMPI-7X400 Operation Manual

PROCISE™ Surround Sound Amplifier

Operation

Turn Power On or Off
Clear Fault Indicator
Reset Circuit Breaker
22 • PROCISE™ Surround Sound Amplifier: PROAMP(I)-7X400
To turn the amplifier power on, move the switch on the front of the amplifier to the
position.
To turn the power off, move the switch on the front of the amplifier to the
position. The amplifier's microprocessor will reset and continue to receive power.
In the event a channel detects overcurrent, over/under voltage, channel temperature,
or DC offset voltage, its FAULT LED will light. To clear the FAULT LED, press
the recessed RESET button on the front of the amplifier.
NOTE: Before pressing RESET, verify that the cause of the fault is no longer
present.
The amplifier is equipped with two circuit breakers that will open in the event an
internal short is detected. To reset a breaker, turn off the amplifier power as
described above, then press the breaker's reset button on the rear of the amplifier.
NOTE: Before resetting the breaker, verify that the cause of the short is no longer
present.
Crestron PROAMP(I)-7X400
Operations Guide – DOC. 6976A