Table of Contents
Advertisement
Instruments
and indi cato r Lights
Display content
In the Infotainment
system, you can specify
which information should be displayed : For ex-
ample , this can include navigation information*,
Adapt ive cruise control * or night vision assist *.
The display of certain information and some of
the red indicator lights cannot be hidden in the
Infotainment
system.
Display brightness
You ca n adjust t he display brightness in the Info-
tainment system. The display brightness decreas-
es automatically as t he amount of light decreas-
es. The basic level of brightness is adjusted with
the instrument
illum ination ¢ page 47 .
(D
Note
To prevent scratches on the g lass covering the
Head-up display, do not place any objects in
the projection opening.
@
Tips
- Sunglasses w ith polar izat ion filters and un-
favorable lighting cond itions can affect the
display.
- An optimum display depends on the seat
position and the height adjustment
of the
head-up display.
- A specia l windshield is needed for the head-
up display function.
- For informat ion on cleaning, refer to
Q
ta-
ble on page
207.
On Board
Diagnostic
System
(OBD}
Malfunction Indicator Lamp (MIL)
The Malfunction Indicator Lamp (MIL)
¢..ifl
in the
instrument cluster is part of the On-Board Diag-
nostic (OBD II) system.
The warning/indicator
light illuminates when the
ignit ion is switched on and goes out after the en-
gine starts and the idle has stabilized. This indi-
cates that the MIL is working properly.
If the light does not go out after the eng ine is
started, or illuminates while you are dr iving, a
28
malfunction may exist in the engine system. If
the light illum inates , the catalytic converter
could be damaged.
Continue driving with reduced power (avoiding
sustained high speeds and/or rapid accelerations)
and have the condition corrected. Contact your
authorized Aud i dea ler.
If the ligh t illuminates, the e lectronic speed lim-
iter may also be ma lfunctioning . For more infor-
mation ¢ page 29, Electronic speed limiter.
An improperly closed fuel filler cap may also
cause the MIL light to illuminate
Q
page 212.
On-Board Diagnostics
Fig. 16 Locat ion of Data Link Connector (DLC)
On-Board Diagnostics monitors the components
of your emission control system. Each monitored
component in your engine system has been as-
signed a code . In case of a malfunct ion, the com-
ponent will be identified and the fault stored as a
code in the control module memory .
The MIL light may also illuminate if there is a
leak in the on -board f uel vapor recove ry system.
If the light illuminates after a refuelling, stop the
vehicle and make sure the fuel filler cap is prop-
erly closed
c:>
page 212.
In order to make an accurate diagnosis, the stor -
ed data can only be displayed using specia l diag-
nostic equipment (generic scan tool for 080).
In order to connect the specia l diagnostic equip-
ment, push the plug into the Data Link Connector
(DLC). The DLC is located to the right of the hood
release ¢ fig. 16.
..,.
Advertisement
Table of Contents
