Table of Contents
Advertisement
M
N
<(
I.J
"".
rl
I.O
"'
N
I.O
rl
Taking the wheel off/installing the spare
Follow these instructions step-by-step for chang-
ing the wheel .
Fig. 209 Changing a wheel: using the screwdriver handle
(with the blade removed) to turn the bolts
Fig. 210
Changing a wheel: alignment pin inside the to p
hole
After you have loosened a ll wheel bolts and
raised the vehicle off the ground, remove and re-
place the whee l as fo llows:
Removing the wheel
.. Use t he
hexagonal socket
in
the screwdriver
handle
to completely remove the topmost
whee l bolt and set it aside on a clean surface
¢fig. 209 .
.. Screw the threaded end of the
alignment pin
from the tool kit hand-tight into the empty bolt
hole ¢fig. 210.
.. The n remove the other wheel bo lts as descr ibed
above .
.. Take off the wheel leav ing the alignment pin in
the bo lt hole
¢0.
Putting on the spare wheel
.. Lift the spare wheel and carefully slide it over
the alignment pin to guide it in place
¢0 .
Emergen
cy assistance
.. Use the hexagonal socket in the screwdriver
handle to screw in and tighten all whee l bolts
slightly.
.. Remove the alignment pin and insert and tight-
en the remaining wheel bolt slightly like the
rest .
.. Turn the jack handle counter-clockwise to lower
the vehicle until the jack is fully released .
.. Use the wheel bolt wrench to t ighten all wheel
bolts firmly
c;,
page 256. Tighten them cross-
wise, from one bolt to the (approximate ly) op-
posite one, to keep the whee l centered.
(D
Note
When removing or installing the whee l, the
rim could hit the brake roto r and damage the
rotor. Work carefully and have a second per-
son help you .
@
Tips
Never use the hexagonal socket in the handle
of the screwdriver to loosen or tighten the
whee l bolts.
- Pull the reversible blade from the screwdriv -
er before you use the hexagonal socket in
the handle to turn the whee l bolts.
- When mount ing tires w ith
unidirectional
tread design
make sure the tread pattern is
pointed the right way
c;,
page 259.
- The wheel bolts shou ld be clean and easy to
turn. Check for dirt and corrosion on the
mating surfaces of both the wheel and the
hub. Remove all dirt from these surfaces be-
fore remounting the wheel.
Tires with unidirectional tread design
Tires with unidirectional tread design must be
mounted with their tread pattern pointed in the
right direction .
Using a spare tire with a tread pattern
intended for use in a specific direction
When using a spare t ire with a tread pattern in-
tended for use in a specific direction, please note
the following:
- The direction of rotation is marked by an arrow
on the side of t he tire .
.,.
259
Advertisement
Table of Contents
