Table of Contents
Advertisement
M
N
<(
(.J
'SI:
,....,
\!)
..,.,
N
\!)
,....,
~
To activate the high beam assist, tap the lever
forward
(D.
The
ID
indicator light appears in
the instrument cluster disp lay and the high
beam assist is switched on/off automatically.
The
El
indicator ligh t also turns on if the high
beams are switched on .
Switching the high beam s on/off manually
If the high beams did not switch on/off automat-
ically as expected, you may switch them on or off
manually instead:
~
To switch the high beams on man ually, tap the
lever forward
(D.
The
El
indicator light turns
on.
~
To switch the high beams off manua lly, pull the
lever back @ . The high beam assist is deacti-
vated.
Operating the headlight flasher
~
To operate the headlight flasher when the high
beam assist is activated and high beams are
switched off, pull the lever back @ . The high
beam assist remains act ive.
Messages in the instrument cluster display
r!IJ
Audi adaptive light: system fault!
High beam assist: System fault
Drive to an authorized Audi dealer or authorized
Audi Service Facili ty immediately to have the
malfunct ion corrected. You can still switch the
high beams on or off manua lly.
High beam assist: Unavailable No camera view
The camera view is blocked, for example by a
sticker or debr is.
The sensor is located between the interior rear-
view mirror and the windshie ld. Therefore, do not
place any st ickers in this area on the windshield.
A
WARNING
-
High beam assist is only intended to assist
the driver. The driver is still responsible for
controlling the headlights and switching
them manually depending on light and visibil-
ity cond itions. It may be necessary to operate
them manually in situations such as:
Lights
and Vision
- In adverse weather conditions such as fog,
heavy rain, blow ing snow or spraying water.
- On roads where oncoming traffic may be
partially obscured, such as expressways.
- When there are road users that do not have
sufficient lig ht ing, such as bicyclers or
vehicles with dirty tail lamps.
- In tight curves and on steep slopes.
- I n poorly lit areas.
- With strong reflectors, such as signs.
- If
the area of the windsh ield near the sensor
is fogged over, dirty, icy or covered with a
sticker.
Adjusting the exterior lighting
The settings are adjusted in the MMI.
~ Select:
!CARI
function button> (Car)* systems
control button > Vehicle settings > Exterior
lighting .
Automatic headlights
You can adjust the following sett ings in the Auto-
matic headlights menu:
Headlights activation time - You can adjust if the
headlights switch on Early, Med. or Late accord-
ing to the sensit ivity of the light sensor.
Audi adaptive light* - You can switch adaptive
light On and Off.
Automatic high beams*
You can switch the high beam assist on and off .
Daytime running lights
USA models: You can switch the daytime running
lights on and off .
Canada models: The function cannot be turned
off. It is activated automat ically each t ime the ig-
nition is switched on. This menu item is show n
"greyed out".
Coming home, Leaving home
The coming home function illuminates the area
outside the vehicle when you switch the ignition
off and open the driver's door. To turn the func-
t ion on, select Lights when leaving car > On.
..,.
45
Advertisement
Table of Contents
