Table of Contents
Advertisement
M
N
<(
I.J
"".
rl
I.O
"'
N
I.O
rl
Switching on and off
Applies to vehicles: with Audi active lane assist
Fig. 100
Turn signal lever : active lane assist button
Fig. 101
Windshield: camera window for active lane assis t
... Press the¢
fig. 100
button to switch the sys-
tem on and off. The.
or.
indicator light in
the instrument cluster turns on or off .
Indicator lights
•
Ready: The indicator light turns on when the
system is ready for use. The system can now be
operated .
•
Not ready: The ind icator light turns on if the
system is switched on but is inoperable . This may
be due to the following reasons:
- There is no lane marker line.
- The relevant lane marker lines are not detected
(for example, markings in a construction zone
or because they are obstructed by snow, dirt,
water or backlighting).
- The vehicle's speed is below the speed needed
to activate it, which is about 40 mph (65 km/
h).
- The lane is narrower than about 8 ft. (2.5 m) or
wider than 15 ft (4.5 m).
- The curve is too sharp.
Audi
active
lane assist
- The driver's hands are not on the steering
wheel.
(D
Tips
Make sure the camera's field of view
¢
fig. 101
is not obstructed by stickers or any-
thing else. For information on cleaning, refer
to ¢ page
205.
Lane assist display in the instrument
cluster
Applies to vehicles: wit h Audi act ive lane ass ist
Fig. 102 Instrument cluster: active lane assis t is switched
on and providing warnings
Fig. 103
Instrumen t cluster: act ive lane ass ist is switched
on but not ready to provide warn ings
You can call up the active lane assist display using
the buttons in the multifunction steering wheel
¢ page
23.
An additional ind icato r appears in the Head-up
display* .
95
Advertisement
Table of Contents
