Table of Contents
Advertisement
Wheels
the recommended tire pressure for your vehicle
¢
page 243, fig. 198.
Tire tread circumfe rence and vibration character-
istics can change and cause a tire pressure warn-
ing if:
- the tire pressure in one or more t ires is too low .
- the tire has structural damage .
- the tire was replaced or the tire pressure was
changed and it was not stored ¢ page
252.
- the spare tire* is installed .
Indicator lights
IE
Loss of pressure in at least one tire ¢ .&..
Check the tires and replace or repair if necessary.
Check/correct the pressures of all four tires and
store the pressure again in the Infotainment sys-
tem ¢page
252 .
mm
(Tire Pressure Monitoring System) Tire pres-
sure: System malfunction!. If ffim appears after
switching the ignition on or while driving and the
IE
indicator light in the instrument cluster
blinks for approximately one minute and then
stays on, there is system malfunction . Try to
store the correct tire pressures¢ page
252.
If
the indicator light does turn off or turns on again
after a short period of time, drive to your author-
ized Audi dealer or authorized Audi Service Facili-
ty immediately to have the malfunction correct-
ed.
A
WARNING
- If the tire pressure indicator appears in the
display, reduce your speed immediately and
avoid any hard steering or braking maneu-
vers. Stop as soon as possible and check the
t ires and their pressure .
- The driver is responsible for maintaining the
correct tire pressure. You must check the
tire pressure regularly.
- Under certain conditions (such as a sporty
dr iving style, winter cond itions or unpaved
roads), the tire pressure monitoring system
indicator may be delayed.
- Do not use run-flat tires on your veh icle. Us-
ing them when not permitted can lead to
vehicle damage or accidents.
252
(D
Tips
- The tire pressure monitoring system can al-
so stop working when there is an ESC mal-
function.
- Using snow chains may result in a system
malfunction.
- The tires with the identification "AO" or
"RO" ¢ page 240 have been matched with
your Audi tire pressure monitoring system.
We recommend that you use these tires.
Storing tire pressures
If the tire pressure changes or a tire is replaced,
it must be confirmed in the Infotainment sys-
tem.
... Make sure before storing that the tire pressures
of
all four tires meet the specified values and
are adapted to the load ¢ page 243 .
... Switch the ignition on .
... Select: the
I CARI
function button
>
(Car)* Sys-
tems control button
>
Servicing
&
checks > Tire
pressure monitoring > Store tire pressures
>
Yes, store now.
(D
Tips
Do not store the tire pressures if snow chains
are instal led.
Advertisement
Table of Contents
