Table of Contents
Advertisement
M
N
0
I.J
"".
rl
I.O
"'
rl
"'
rl
In s trument
s a nd warning
/ indicator
lights
29
Adjusting the height
The height of the display can be adj uste d to
t he individual driver.
.. Make sure you are seated cor rect ly
<=>page 127.
.. Turn the knob~
to adjust the displ ay.
Settings in the MMI
.. Select:
I CARI
funct ion button
>
(Car)* sys-
tems control button
>
Driver Assist > Head-
up Display > Head-up Display content or
Display brightne ss.
Display content
In the MMI, you can specify which information
should be displayed :
- Cruise contro l system*
- Navigatio n information*
- Audi adaptive cruise control *
- Audi act ive lane assist*
- Night vis ion assistant*
The speed display and some of the red indica-
tor lights cannot be hidden in the MMI.
Display brightness
You can adju st the display brightness in t he
MMI. The display brightness decreases auto-
mat ically as the amount of light decreases.
The basic level of brightness is adjusted with
the inst rumen t il lum inati on ¢ page 46 .
(D
Note
To prevent scratches on t he glass covering
the Head-up Display, do not place any ob-
jects in the proj ection opening.
(D
Tips
- Sunglasses w ith polar izat ion fi lters and
unfavorable lighting condit ions can af-
fect t he display.
- A special w indshield is needed for the
Head-up Display funct ion.
- For information on cleaning, refer to
¢
table on page 211.
On-Board
Diagnostic
system
(OBD)
Malfunction Indicator Lamp (MIL )
The Malfunction Indicator Lamp (MI L)
¢'4
in
the instr ument cluster is part of the On-Board
Diagnostic (OBD II) system .
The wa rni ng/indicator light ill uminates when
the ignit ion is switched on and goes out after
the engine sta rts and the idle has stab ilized.
This indicates that the MIL is working proper-
ly.
If the light does not go out afte r t he engine
is started, or illuminates while you are dr iv-
ing, a malf unction may exist in the engine sys-
tem.
If
the lig ht illum inates, the catalyt ic con-
verter could be damaged .
Contin ue driving with reduced power (avoid-
ing sustained high speeds and/or rapid accel-
erations) and have the cond ition corrected.
Contact your aut horized Audi dealer.
If the light illuminates, the electronic speed
limiter may also be malfunct ioning . For more
information
c>
page 30, Electronic speed
limiter.
An improperly closed fuel filler cap may also
cause the MIL light to illuminate
c>page 216.
On-Board Diagnostics
Fig. 1 6 Locat ion of Data Link Conn ector (DLC)
On-Board Diagnostics monitors the com po-
nents of your emission cont rol system. Each
monitored component in your engine system
Iii>-
Advertisement
Table of Contents
