Table of Contents
Advertisement
In
s
trumen
ts
and ind
ica
tor ligh
ts
still control all wiper functions that are
independent of the rain sensor.
Drive to an authorized
Audi
dea ler or authorized
Audi
Service Facility immediately to have the
malfunction corrected
.
; Adaptive dampers
Applies
to
vehicles: with Audi
drive
select
R
Sus pension:
system fault!
There is an adaptive damper ma lf unction.
Drive to an authorized
Audi
dealer or authorized
Audi
Service Facility immediately to have the
malfunct
ion
corrected.
¢¢
Turn signals
If the
.
or
DI
indicator
light
blinks, a turn sig-
nal
is turned on. If both indicator lights are blink-
ing, the emergency flashers are
on.
In an indicato
r
light blinks twice as fast as usua
l
then a blinker bulb has failed. Carefully drive to
an author ized Audi dealer or authorized Audi
Service Facility immediately to have the malfunc-
tion corrected.
(D
Tips
For more information on the turn signals,
re-
fe
r
to~
page 48.
On-Board
Diagnostic
system
(OBD)
System indicator light (MIL)
The system indicator light (MIL)
¢4
in the instru-
ment cluster is part of the On Board Diagnostic
System (080 II).
The warning/indicator light turns on when the ig-
nition is switched on and turns off once the en-
gine is started and is running in idle at a stable
speed.
This
indicates that the MIL is functioning
correctly.
If the light doe
s
not turn off after starting
the
engine
or turns on while driving, this may indi-
cate there is a malfunct ion in the engine. If the
26
indicator tu rns on, the cata lytic conve rter may be
damaged.
Drive
with reduced engine performance
(avoid
high speeds for extended per iods of t ime and/o
r
fast acceleration) and have the ma lfunction
cor-
rected. See an authorized Audi dealer or author-
ized Audi Service
Facility.
The ind icator may
t
urn on if the electro nic speed
limiter is faulty
.
For add itiona
l
information, refer
to
c::>
page
130,
Electronic speed limiter.
The MIL may also turn on if the fuel filler cap is
not
clos
ed correctly
c::>
page
230.
On-Board Diagnostics
Fig. 7
Locat
ion of Data Link Connector
(DLC)
On-Board Diagnostics mon itors the components
of your emission
cont
rol system. Each monitored
component in your engine system has been as-
s igned a code
.
In case
of
a malfunction, the com-
ponent will be identified and the fault stored as a
code in the contro
l
module memory.
The MIL light may also illum inate if there is a
leak in
t
he on -boa rd fuel vapor recovery
syst
em
.
If the light illuminates after a refuelling, stop
the veh icle and make sure the fuel filler cap is
properly closed
c::>
page
230.
In orde
r
to make an accurate diagnosis, the
st
or-
ed data can only be displayed using special diag-
nostic
equipment
(generic scan tool for 080)
.
In orde
r
to connect
t
he special diagnost ic equ ip-
ment, push the plug into the Data Link Connector
(DLC). The DLC is located to the right of the hood
release
c::>
fig.
7.
II>
Advertisement
Table of Contents
