Table of Contents
Advertisement
Warm and col d
At both of these settings, the climate control sys -
tem runs continuously at maximum cooling or
heating power. There is no temperat ure regula-
tion.
Adjust ing th e blower [!]
You can adj ust the volume of air generated by the
blower to your preference. To have the blower
reg ulated automatically, press the
!AUTO
I
button .
~
Adjust ing air distribution
You ca n manually se lect the vents whe re the air
will flow. To have the air distrib ution regu lated
automatically, press the
!AUTO !
button .
~
Adjusting seat heating * / seat vent ilation*
Pressing the button switches the seat heating/
seat ventilat ion on at the highest setting (leve l
3). The LEDs indicate the tempe ratu re leve l. To
red uce the tempe ratu re, press the butto n aga in.
To switch the seat heating/seat
venti lation off,
press the button repeatedly until the LED turns
off.
After 10 minutes, the seat heating automatically
switches from leve l 3 to leve l 2 .
I@
FRONT
I
Switching the defroster on/ off
The windsh ield and s ide windows are defrosted
or cleared of condensation as quickly as possible.
The max imum amo unt of air flows ma inly from
t he ven t s below the windshie ld. Recirculat ion
mode switches off. The temperature
shou ld be
set to approximately 22 °C.
The
IAUTOI
button swit ches the defroster off.
IOiil REAR I
Switching the rear window defogger
on/ off
The rear window heater only operates when the
eng ine is running. It sw itches off automatically
after a few m inutes, depend ing on the outs ide
temperature.
To prevent the rear window heater from switc h-
ing off a utomat ica lly, press and hold the
!l:iil
REAR
I
button fo r more t han 2 seconds. This rema ins
stored until the ignition is switched off.
72
I
SYNC
I
Synchronizat ion
When synchroni zation is swi t ched on, t he set-
tings for the driver's side a re applied to the front
passenger's side (except for seat heating/ventila-
tion*). The settings in the rear are also synchron-
ized. Synchronization switches off if the settings
are adjusted on the front passenger's side or in
the rear.
You can synchronize the settings in a row by
pressing and holding a control. For example, to
apply the settings for the front passenger's side
to the driver's side, press and ho ld the control on
the front passenger's side. The same applies to
the rear .
Residual heat*
With the ign ition turned off, you can activate the
residual heat function by pressing the
[!:I
button
<=>
fig . 76 . The residua l heat from the coolant is
used to heat the veh icle interior. The residual
heat funct ion switches off automatically after
about 30 minutes.
Air vents
You can open or close the center and rear vents in
the cockpit and the vents in the rear center con-
sole and door pillars using the ridged thumb-
whee ls . The levers adjust the direct ion of the air-
flow from the vents.
.8,
WARNING
- You should no t use the recirculation mode
for an extended period since no fresh air is
drawn in. With the a ir-conditioning switched
off, the windows can fog up, which increases
the risk of an accident.
- Individ ua ls with red uced sensitivity to pain
or temperat ure could deve lop burns when
using the seat heating f unction. To reduce
the risk of injury, these indiv iduals should
not use seat heating .
(D
Note
To avoid damage to the heating e lements in
the seats, do not kneel on the seats or place
heavy loads on a small area of the seat.
Advertisement
Table of Contents
