Advertisement
Default configuration settings
Movement and ignition detection:
Vehicle movement will be detected
by accelerometer
Device makes a record On Moving if one of these events happen:
300 seconds passes
Vehicle drives 100 meters
Device makes a record On Stop if:
1 hour passes while vehicle is
stationary and ignition is off
Records sending to server:
If device has made a record it is
sent to the server every 120
seconds
After successful SMS configuration, FMU130 device will synchronize time and update records to
configured server. Time intervals and default I/O elements can be changed by using
Configurator
or
SMS
Mounting recommendations
Connecting wires
Wires should be connected while the module is not plugged in.
Wires should be fastened to stable wires or other non-moving parts. Any heat emitting
and/or moving objects should be kept away from the wires.
There should be no exposed wires. If factory isolation was removed while connecting
wires, the isolation material should be applied.
If the wires are placed in the exterior or in places where they can be damaged or
exposed to heat, humidity, dirt, etc., additional isolation should be applied and the wires
should not be loose.
Wires cannot be connected to the board computers or control units.
Connecting power source
Be sure that after the car computer goes to sleep mode, power might be still available on
the power wires. Depending on car, this may happen in 5 to 30 minutes period.
When module is connected, measure voltage again to make sure it did not decrease.
It is recommended to connect to the main power cable in the fuse box.
3 A, 125 V external fuse shall be used.
parameters.
Ignition will be detected by
vehicle power voltage
between 13,2 – 30 V
Vehicle turns 10° degrees
Speed difference between
last coordinate and current
position is greater than 10
km/h
Teltonika
Advertisement
