Mounting Recommendations - Teltonika FMC150 First Start-Up Quick Start Manual

Once the CAN configuration upload task has been assigned, it can be seen in the main window.
Please note, that uploading will start after the next scheduled connection to FOTA WEB (or
instant connection, initiated by an SMS command "web_connect"):
When the task is completed you can validate if you have uploaded the correct file by checking
the "Changes" tab, where the vehicle make and model are shown.

Mounting recommendations

Connecting wires
Wires should be connected while the module is not plugged in.
Wires should be fastened to stable wires or other non-moving parts. Any heat emitting
and/or moving objects should be kept away from the wires.
There should be no exposed wires. If factory isolation was removed while connecting
wires, the isolation material should be applied.
If the wires are placed in the exterior or in places where they can be damaged or
exposed to heat, humidity, dirt, etc., additional isolation should be applied and the wires
should not be loose.
Wires cannot be connected to the board computers or control units.
Connecting power source
Be sure that after the car computer goes to sleep mode, power might be still available on