Toyota RAV4 PHEV 2023 Owner's Manual page 557

may get dirty.
18Temporarily store the bottle in
the luggage compartment while
it is connected to the compres-
sor.
19To spread the liquid sealant
evenly within the tire, immedi-
ately drive safely for about 5 km
(3 miles) below 80 km/h (50
mph).
20After driving, stop your vehicle in
a safe place on a hard, flat sur-
face and reconnect the repair
kit.
Remove the air release cap from the
hose before reconnecting the hose.
21Turn the compressor switch on
and wait for several seconds,
8-2. Steps to take in an emergency
then turn it off. Check the tire
inflation pressure.
A If the tire inflation pressure is
under 130 kPa (1.3 kgf/cm
bar, 19 psi): The puncture can-
not be repaired. Contact any
authorized Toyota retailer or
Toyota authorized repairer, or
any reliable repairer.
B If the tire inflation pressure is
130 kPa (1.3 kgf/cm
psi) or higher, but less than the
specified air pressure: Proceed
to step 22.
C If the tire inflation pressure is the
specified air pressure (P.590):
Proceed to step 23.
22Turn the compressor switch on
to inflate the tire until the speci-
fied air pressure is reached.
Drive for about 5 km (3 miles)
and then perform step 20.
23Attach the air release cap to the
end of the hose.
If the air release cap is not attached,
the sealant may leak and the vehicle
555
2
or
2
or bar, 19
8
OwnersManuals2.com