Toyota RAV4 PHEV 2023 Owner's Manual page 376

374 5-5. Using the driving support systems
*1
: When the set speed is shown in
"km/h"
*2
: When the set speed is shown in
"MPH"
 Increasing the set speed by the
accelerator pedal
1 Accelerate with accelerator
pedal operation to the desired
vehicle speed
2 Press the "-SET" switch
Changing the vehicle-to-
vehicle distance (vehicle-to-
vehicle distance control
mode)
Pressing the switch changes the
vehicle-to-vehicle distance as fol-
lows:
1 Long
2 Medium
3 Short
If a vehicle is running ahead of you, the
A
preceding vehicle mark
displayed.
Vehicle-to-vehicle distance
settings (vehicle-to-vehicle
distance control mode)
Select a distance from the table
below. Note that the distances
shown correspond to a vehicle
speed of 80 km/h (50 mph).
Vehicle-to-vehicle distance
increases/decreases in accor-
dance with vehicle speed. When
the vehicle is stopped by system
control, the vehicle stops at a cer-
tain vehicle-to-vehicle distance
depending on the situation.
Distance options
Long
Medium
Short
Resuming follow-up cruis-
ing when the vehicle has
been stopped by system
control (vehicle-to-vehicle
distance control mode)
After the vehicle ahead of you
starts off, press the "+RES" switch.
will also be
Your vehicle will also resume fol-
low-up cruising if the accelerator
pedal is depressed after the vehicle
ahead of you starts off.
Vehicle-to-vehicle
distance
Approximately 50
m (160 ft.)
Approximately 40
m (130 ft.)
Approximately 30
m (100 ft.)
OwnersManuals2.com