Sony SVO-5800 Operating Instructions Manual page 29

Connection of SVO-5800/5800P (recorder) and FXE-100/100P
When you have just one player, connect the audio/video output connector of the
recorder to the RECORDER INPUT connector of the FXE-100/100P video editing
system. A freeze image of the recorder can be taken into the FXE-100/100P in A
roll editing, and mixing or wipe is possible with the player's image. Also, you can
check the playback signal of the tape in the recorder (master tape) on the main
monitor.
75-ohm termination Reference input level
switch: ON selector: +4dBm
S video cable
S video cable
PGM 1 S VIDEO OUTPUT
S VIDEO IN |
BNC cable
REMOTE 9P F AUDIOIN | IN
CH-1/CH-2 AUDIO OUT RECORDER
CH-1/CH-2 AUDIO UR
INPUT
RK-5XLAF phono +» XLR 3-pin conversion cable
RK-5XLRM phono ++ XLR 3-pin conversion cable
Reference output level RCC-5G 9-pin remote cable
selector: +4dBm
a) As PGM 1 and PGM 2 output the same signal, you can connect to either of them.
Connection of SVO-5800/5800P (recorder) and FXE-100/100P
e To the REF VIDEO IN connector of the recorder, input the output signal from
the PGM 1/2 VIDEO OUTPUT connector, not from B.B OUT of FXE-100/100?.
e As the REF VIDEO IN connector of the SVO-5800/5800P/S VP-5600/5600P is
loop-through, the output of the signal generator can be bridge connected via eaca
piece of equipment. Set the 75-ohm termination switch to OFF for bridge
connection. Set it to ON when bridge connection is not made or the unit is the
terminal equipment in the bridge connection.
Using the Unit in a System
Using the Unit in a System
29(E)