Trane S8V2A040M3PC Installation, Operation And Maintenance Manual page 39

Upflow Furnace with Bottom and Side Returns Mounted on a
Ducted Pedestal with Side Return and Filter Box
Important: Make sure the thermostat wiring hole is sealed on the
cabinet side with the side return.
Important: Make sure not to cut the cabinet in the "No Cut" area.
Note: Use Optional BAYLIFT kit to lift furnace. Follow kit instructions.
Note: The furnace bottom pedestal must be a minimum of 6" in
Refer
Upflow Furnace with Side Return
Important: Make sure the thermostat wiring hole is sealed on the
cabinet side with the side return.
Important: Make sure not to cut the cabinet in the "No Cut" area.
Note: If using a filter box, use a transition, if possible, to attach the
filter box to the furnace cabinet.
No Cut Area
Refer Step 9.
S8V2-SVX001-1A-EN
height.
Step 1. to Step 8.
Use four corner guides
to create cutout
to Step 12.
F F u u r r n n a a c c e e G G e e n n e e r r a a l l I I n n s s t t a a l l l l a a t t i i o o n n
Cabinet cutout when used with BAYLIFT
21" Filter Cabinet with BAYLIFT Kit shown
No Cut Area Cutouts
Upflow Furnace with Two Side Returns
Important: One of the sides must have a transition to allow the
thermostat wiring to exit the cabinet.
Important: If a transition is not a viable option, a hole will need to be
drilled in the side of the cabinet for the thermostat wiring
Important: Make sure not to cut the cabinet in the "No Cut" area.
Note: If using one transition, the thermostat wiring will exit on the
Note: If using a filter boxes, use transitions, if possible, to attach the
filter boxes to the furnace cabinet.
No Cut Area
Refer Step 9.
Flush with back
of furnace cabinet
to exit.
transition side.
Use four corner guides
to create cutout
to Step 12.
39