Troubleshooting - Summit FF64BSS User Manual

You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Appliance is not connected to a power
Appliance supply.
does not The appliance is turned off.
operate. Tripped circuit breaker or a blown fuse.
The temperature is not set correctly.
The ambient temperature could require
a lower temperature setting.
The doors were opened too often.
Appliance is
not cold A door was not closed completely.
enough. Doors are not hermetically sealed.
The condenser is too dirty.
The ventilation opening is blocked or too
dusty.
The room temperature is higher than
average.
A large amount of food has been added
Appliance to the unit.
turns itself on
and off The doors are opened too often.
frequently.
A door is not closed completely.
A door gasket is not sealing properly.
Appliance is not connected to a power
supply.
The light does
Tripped circuit breaker or a blown fuse.
not work.
The light was switched off on the control
panel.
The appliance is not properly leveled.
Vibrations
A rattling noise may come from the flow of the refrigerant, which is normal. As
each cycle ends, you may hear gurgling sounds caused by the flow of
The appliance
refrigerant in your appliance.
seems to
If temperature fluctuations occur, the contraction and expansion of the inner walls
make too
may cause popping and crackling noises.
much noise.
The appliance is not properly level.
The appliance is not properly level.
The doors will
not close
The gaskets are dirty.
properly.
The shelves are out of position.
Display "E0", "E0" indicates a communication error for
"E1". "E2",
3-zone models.

TROUBLESHOOTING

POSSIBLE CAUSE
Connect the appliance.
Switch on the appliance.
Switch on circuit breaker or replace
fuse.
Check the set temperature.
Set a lower temperature.
Do not open the doors more often
than necessary.
Close door properly.
Check the door seal and clean or
replace.
Clean the condenser when necessary.
Clear the obstructions and clean the
dust.
Put the appliance in a cooler place.
Leave the appliance to work for a
while until the set temperature has
been reached.
Do not open the doors more often
than necessary.
Close door properly.
Check the door seal and clean or
replace.
Connect the appliance.
Switch on circuit breaker or replace
fuse.
Switch on the light.
Level the appliance with the
adjustable feet.
Level the appliance with the
adjustable feet.
Level the appliance with the
adjustable feet.
Clean the door gaskets.
Check the shelves and refit correctly.
Call for service.
25
REMEDY