Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Before Using your Appliance
Remove the exterior and interior packing.
•
CAUTION: After unpacking you MUST allow this appliance to stand upright for at least 2
hours to allow the lubricant and refrigerant to drain back into the compressor
and stabilize. Failure to do so may adversely affect performance and the
lifetime of this unit.
Clean the interior surface with lukewarm water using a soft cloth.
•
Install the handle on the door. (See Installing the Stainless Steel Handle.)
•
Installation of your Appliance
CAUTION: This appliance is designed for storing and cooling fresh food, beverages,
and drinks. Do not store perishable food, medicine, or other medical products.
The appliance is designed for built-in, recessed, or free-standing installation for indoor use only
•
for models ASDS1523, ASDS2413, FF1532BSS, SCFF1533BSS, AL54IF, FF64BSS,
SCFF53BSS, SCR610BLSD, and FFRF24SS. And for indoor or outdoor use for SPR618OSADA
only.
NOTE: Do not store or install the appliance outdoors for models with indoor use only.
Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level
•
the unit, adjust the front leveling legs.
For freestanding installation, leaving 5" (127mm) of space at the back and sides of the unit and
•
4"(102mm) at the top is suggested, which allows the proper air circulation to cool the compressor
and condenser to save energy. For built-in installation, it is better to leave at least ¼" (5mm) of
space on each side, 2" (50mm) at the back, and ⅛" (3mm) at the top to ensure proper service
access and ventilation. And the air vent at the front of the appliance must never be covered or
blocked in any way.
CAUTION: Make sure that the socket and ON/OFF switch are easily accessible after
the appliance has been installed.
Avoid locating the unit in moist areas.
•
Plug the appliance into an exclusive, properly grounded wall outlet. Do not under any
•
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
NOTE:
It is recommended that you do not install the appliance near an oven, radiator, or other
heating sources. Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Do not install in a location where the temperature will fall
below 60°F (16°C). For best performance, do not install the appliance behind a cabinet door
or block the base grille.
10
Advertisement
Table of Contents
