Related Manuals for Summit FELIX STORCH FF-6
Summary of Contents for Summit FELIX STORCH FF-6
- Page 1 FELIX STORCH, INC. SUMMIT APPLIANCE DIVISION® INSTRUCTION MANUAL FOR MODEL(S): All Variations of the FF-6 All Variations of the FF-7 & All Variations of the SCR-600L/SCR-600BL ALL-REFRIGERATOR...
-
Page 2: Table Of Contents
Write the model and serial numbers here: Model#_____________________ Serial #___________________ Find these numbers on the back of the unit Table of Contents Before Putting into Use … IMPORTANT Disposing of worn out Appliance…. Placing and Installation Choosing the right Place…………………. Connection to Power Supply……………….. -
Page 3: Before Putting Into Use
*Before Putting Into UsE* Before connecting the appliance to the power supply, leave it standing for about 2 hours, this will reduce the possibility of malfunctions in the cooling system due to transport handling. Clean the appliance thoroughly; especially in the interior (See Cleaning and Maintenance). -
Page 4: Important
IMPORTANT If you bought this appliance to replace an old one equipped with a lock that cannot be opened from inside (lock, bolt), make sure that the lock is broken. This will make it impossible for children to lock themselves inside the appliance and suffocate. -
Page 5: Placing And Installation
PLACING AND INSTALLATION It is important to make sure the appliance is leveled evenly to prevent falling. Two spacers attached to the appliance must be fitted onto the upper edge of the condenser, thus preventing the appliance from being installed too close to the wall. Spacers are manufactured for all-purpose functions depending on the distance of the condenser from the wall. -
Page 6: Operation Control
Operation control How To Adjust The Thermostat The refrigerator is controlled with a thermostat knob located inside unit, towards the right-hand corner. Turn the knob clockwise from the STOP (0) position toward higher numbers for colder temperatures. TEMPERATURE SELECTION The settings of the temperature control are from 0 (off) to 7 (max). Initially adjust the temperature control setting to 4 (norm), then adjust the thermostat to colder or warmer (as needed). -
Page 7: Storing Fresh Food
Storing Fresh Foods Foods to be stored in the refrigerator should be properly packed as to prevent mixing various moisture degrees and odors (in polyethylene bags or sheet, aluminum foil, wax paper, covered containers or bottles). Never store any inflammable, volatile or explosive substances. Beverages with high alcohol percentage shall be stored in tightly sealed bottles in a vertical position. -
Page 8: Automatic Defrosting Of The Refrigerator
There is no need to defrost the refrigerator, because the ice depositing on the inner back wall is defrosted automatically. Ice may deposit on the inner back wall during the compressor operation; later on when the compressor is not operating, the ice is defrosted and the water is collected and drained through the outlet in the inner back wall into the drain pan situated above the compressor where it is evaporated. -
Page 9: Reversing The Door
Door swing reversal Stainless steel models with towel bar handles do not have reversible doors.) If you find the direction of opening the door on your appliance inconvenient, you can change it. Holes on the opposite side have already been prepared at the factory 1. -
Page 10: Adjusting The Level Legs
Adjusting the Level legs The Professional units (those with a BI suffix in model number) have 4 adjustable level legs. By turning the legs counter-clockwise you can increase the height of the unit up to 34” inches high or you may decrease the height to about 33”... - Page 11 Ice Formation on the Inner Rear Wall Possible Causes *The door does not seal well (clean the gasket if it is contaminated, or replace it if it is damaged). *The door was frequently opened or it was left opened for too long. *The food stored in the refrigerator was warm.
-
Page 12: Noise
Care sections. You may find the answer to your questions. If you don’t find the answer to your questions in this manual, find the unit model number (on the upper back of the refrigerator) and contact your Summit Appliance Dealer. Specifications are Subject to Change Without...