Table of Contents
Advertisement
to hold the door firmly after removing the screws and place it on a padded surface to avoid the risk
of damage. Leave the hinges open. (Figure 1)
2. Unscrew the four screws (3) to remove the top and bottom articulated hinges. (Figure 2)
3. Pop out the cover caps on the left side of the cabinet and use them to
right-hand side.
4. Pull the top decoration cover (4) upward and remove it. Unscrew the two screws (5) and transfer
the retaining bracket (6) to the opposite side of the door. Refit the top decoration cover (4). (Figure
3)
5. Unscrew the screw (8) and transfer the bottom decoration cover (7) to the opposite side of the door.
(Figure 4)
6. Refit the articulated hinges to the opposite side of the door by using the four screws (3). (Repeat
step 2 in reverse.)
7. Refit the door to the opposite side. Then screw and tighten it after the door is leveled. (Repeat step
1 in reverse.)
Adjusting the Height of the Unit
The height of the ADA refrigerators can be increased by up to 3" by turning the adjustable legs. Once
the desired height has been achieved, the gap between the kick-plate and the floor can be covered by
lowering a hidden section of the kick-plate. See the next section for instructions.
Adjusting the Kick Plate
(Only for Models AL54IF / ASDS1523 / ASDS2413 / SPR618OSADA)
The pre-fitted kick-plate of the appliance includes an adjustable
kick-plate section that is initially seated behind the upper section.
In order to adjust the kick-plate height, follow the instructions
below:
1. Remove the screws (1) from both the top left- and top right-
hand sides of the kick-plate.
2. Loosen or remove the screws (2) from both the bottom left and
bottom right-hand sides of the kick-plate. Failure to loosen the
bottom screws sufficiently may cause damage to the lower trim
when adjusting it.
3. Carefully guide the lower trim down until the desired height is achieved.
4. Reinsert screws and tighten them.
Installing a Stainless Steel Handle
(Only for Models ASDS1523 / ASDS2413 / SPR618OSADA /
SCR610BLSD / FFRF24SS)
This appliance includes a stainless steel handle that is not
required to operate the unit. To install the handle, follow the
instructions below:
Place the handle (1) over the mounting stub (3) of the door and
using the supplied Allen key, tighten the securing grub screws
(2) to affix the handle.
14
cover the screw holes on the
3
1
2
Advertisement
Table of Contents
