Table of Contents
Advertisement
Built-in Under-counter Instructions
Make sure your installation does not block the front ventilation
grille. The unit is designed to fit under worktops.
If the fully integrated unit is to be installed to fit the kitchen
plinth, make sure that the ventilation gaps in the plinth are at
2
2
least 46in
(300cm
) and remove the ventilation grilles, so that
warm air can disperse unhindered. Otherwise, the appliance
has to work harder, resulting in an increase in electricity
consumption.
NOTE: When pushing the appliance into the niche, make sure
that the main cable does not get trapped.
Model No.
(Inch/mm)
FF1532BSS
34" / 864
FF64BSS
34" / 864
AL54IF
32" / 813
ASDS1523
32" / 813
ASDS2413
32" / 813
NOTE:
1. Model SCFF1533BSS is the same size as FF1532BSS.
2. Models SCR610BLSD, FFRF24SS and SCFF53BSS are the same size as FF64BSS.
3. Model SPR618OSADA is the same size as ASDS2413.
Anti-tip Bracket Installation
To reduce the risk of tipping the unit by abnormal usage or improper loading, the appliance must be
secured by properly installing the anti-tip device packed with the appliance.
Place the anti-tip bracket on the floor as shown in the figure. An anti-tip bracket must be
1.
installed on the left side.
Mark the locations of the 4 holes of the anti-tip bracket on the floor.
2.
Use a 5/16" masonry drill bit and insert plastic anchors.
3.
Secure the bracket onto the floor using screws.
4.
Slide the appliance into position and make sure the leg engages the anti-tip bracket.
5.
NOTE:
If the unit is relocated, the bracket must be removed and reinstalled in the new location.
a
b
(Inch/mm)
22¾" / 575
23½" / 596
22¾" / 575
18" / 455
18" / 455
c
A
(Inch/mm)
(Inch/mm)
34⅛" / 866
14⅞" / 377
34⅛" / 866
23½" / 596
32⅛" / 816
23½" / 596
32⅛" / 816
14⅞" / 377
32⅛" / 816
23½" / 596
11
B
C
(Inch/mm)
(Inch/mm)
22¾" / 575
15" / 381
22⅞" / 580
23⅝" / 600
23⅝" / 600
22¾" / 575
18" / 455
15" / 381
23⅝" / 600
18" / 455
Advertisement
Table of Contents
