Troubleshooting - Summit SPR275OS2D User Manual

You can solve many common problems easily, saving you the cost of a service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Appliance does not
operate.
The appliance is not
cold enough.
The appliance turns
itself on and
off frequently.
The light does not
work.
Vibrations
The appliance
seems to make
too much noise.
Display "E1", "E2".
LED displays "HH",
the alarm is ringing
LED displays "LL", the
alarm is ringing

TROUBLESHOOTING

POSSIBLE CAUSE
The appliance defrosts automatically
in normal operating conditions.
The appliance is turned off.
Tripped circuit breaker or a blown
fuse.
The temperature is not set correctly.
The ambient temperature could
require a lower temperature setting.
The condenser is too dirty.
The ventilation opening is blocked or
too dusty.
The room temperature is higher than
average.
A large number of bottles have been
added to the appliance.
The appliance is not connected to a
power supply.
A tripped circuit breaker or a blown
fuse.
The light was switched off on the
control panel.
The appliance is not properly leveled. Level the appliance with
The rattling noise may come from the flow of the refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds caused by the flow of
refrigerant in your appliance.
If temperature fluctuations occur, the contraction and expansion of the inner
walls
may cause popping and crackling noises.
The appliance is not properly leveled. Level the appliance with
"E1" or "E2" indicates that the air
temperature sensor has failed.
The unit's internal temperature is
higher than 86°F (30°C).
The unit's internal temperature is
lower than 32°F (0°C).
Connect the appliance.
Switch on the appliance.
Switch on the circuit breaker or
replace the fuse.
Check the set temperature.
Set a lower temperature.
Clean the condenser when
necessary.
Clear the obstructions and wipe off
the dust.
Put the appliance in a cooler place.
Leave the appliance to work for a
while until the set temperature has
been reached.
Connect the appliance.
Switch on the circuit breaker or
replace the fuse.
Switch on the light.
adjustable feet.
adjustable feet.
Call for service.
Unplug the appliance and re-plug after
5 minutes. If the alarm and LED do not
change back, contact customer
service.
Unplug the appliance and re-plug after
5 minutes. If the alarm and LED do not
change back, contact customer
service.
14
REMEDY