Setting Up Bxc-Cbe1; Attaching The Objectives; Attaching The Nosepiece - Olympus BXC-CBB Instructions Manual

3.6 Setting up BXC-CBE1

1.
Confirm the DIP switch on BXC-CBE1 is set properly.
Set everything to OFF (factory default setting).

3.7 Attaching the objectives

1.
Attach the objectives by screwing them into the nosepiece mounting holes.
NOTE:
Start from the nosepiece mounting hole 1 in the order of the lowest to the highest magnification objective.
l
Attach the objectives starting from the nosepiece mounting hole 1 without leaving any holes in between empty.
l
Make sure to place caps on any holes to which objectives are not attached.
l

3.8 Attaching the nosepiece

If you are not using the motorized nosepiece connector such as when using a manual nosepiece, refer to
motorized nosepiece connector of the motorized light guide reflected light illuminator (page
3. Setup procedures
"Storing the
13)".
3.6 Setting up BXC-CBE1
12