Table of Contents
Advertisement
Appendix A - General Information
Performance Verification
PERFORMANCE VERIFICATION
After the HP 3562A has been installed, you can verify is operation in two steps. First, attach the
power cord to the connector on the rear panel and press the
should appear as in figure A-2. The power-on self test takes several minutes. During this test
"Start Pending" and "DIAGNOSTIC IN PROGRESS" are displayed. The self test must be run
from a power-on (default) state.
1 0 . 0
!Dl.v
'"
rms
,2
Fxd y 0
If the display does not appear as in figure A-2, check to see that the instrument has been
installed properly. If necessary, refer servicing to qualified personnel. The list of HP Sales and
Support Offices is shown at the end of this manual.
Second, activate the self test by pressing the
soft key. After about two minutes, the message ' 'Self Test Passes" should be displayed in the
lower right corner of the screen. If it does, the analyzer is performing properly. If. however, a
failure message is displayed, the analyzer is in need of service.
A-8
Woco
100k
Figure A-2 The H P 3562A Display at Power-On
SPCl FCTN
switch ON. The display
LINE
(Trace data depends on input
connections)
key followed by the SELF TEST
Advertisement
Chapters
Table of Contents
