HP 3562A Operating Manual page 184

THROUGHPUT SETUP CHECKLIST
Here are the steps to create a throughput file on disc, set up a throughput session, and then
measure the throughput file:
Create a 1 . Set file size: use THRUPTSIZE in the DISC FCTN menu (under
file DISC). (page 6·6)
2. Name and create the file: use CREATE THRUPT in the DISC
FCTN menu (under DISC). (page 6·7)
Set up a 1 . Activate throughput: activate LINEAR RES then THRUPT ON OFF
throughput in the MEAS MODE menu. (page 6·9)
session
2. Select throughput channel(s): use CH 1&2 ACTIVE, C H 1 ACTIVE
or CH 2 ACTIVE in the SELECT MEAS menu.
3. Set session length: use THRUPT LENGTH in the THRUPT
SELECT menu. (page 6·9)
4. View the input signals, if desired: use the VIEW INPUT menu.
(page 6·10)
5. Set up the inputs: refer to Chapter 7 for triggering, range, coupling,
calibrating and engineering units. See note regarding triggering on
page 6·11,
6. Identify the active file: use ACTIVE FILE in the THR U PT SELECT
menu. (page 6·11)
7. Start the session: press SlART THRUPT in the THR U PT SELECT
menu. (page 6·11)
8. View the throughput header, if desired: press THRUPT HEADER
in the THRUPT SELECT menu. (page 6·12)
Measure and 1 . Identify the active file: use ACTIVE FILE. (page 6·13)
analyze a
throughput 2. View the active file, if desired: use THRUPT TIME 1 and/or
file THRUPT TIME 2 in the VIEW INPUT menu. (page 6·14)
3. Set the measurement starting point (if other than the beginning of
the file): use the TRIG DELA Y menu. (page 6·14)
4. Set up and start the measurement: refer to Chapter 1 or Chapter 2.
I.Jl lctfJll:Il O-U�Uly I II lit: l l llUUYllfJUl
THROUGHPUT SETUP CHECKLIST
6·17
r- � _��� D I I�:_� -r:_� T .... �� • • �h� �
.... • •