Figure 10 Shielding Clamp For Rs485 - ABB M101 Manual

S W I TC H G E A R BU S N E T W O R K
Parameterization of communication setting in M10x can be done either via the MD panel on
the MNS module front or with a Laptop with 'MCUsetup' software tool installed. For further
detail on changing the setting, refer to " M10x User Guide" document.
In addition to the terminating resistor, it is also required to install a shielding clamp for the
RS485 communication to reduce EMC disturbances. The following figure shows a sample of
the clamp that can be used for shielding purpose.

Figure 10 Shielding Clamp for RS485

16
CO M M U N I CATI O N I N TE R FA CE CO N NE CT IO N
1TG C 9 0 8 0 0 4 M 0 2 0 1