Wireless Setup | Ir Remote - ADJ UV LED BAR20 IR User Instructions

W I R E L E S S S E T U P
There are many factors that can affect and/or interrupt a wireless signal, including walls, glass, metal,
objects, and people. Therefore, the following guidelines are recommended in order to maximize the
chances of having a clear path for the wireless signal to reach the device:
• Install the device a minimum of 9.8 ft (3m) above audiences and/or ground level.
• Arrange the wireless antenna in an upright, vertical position.
• Position devices in direct line of sight of the transmitting controller.
Careful planning and testing of the selected installation location is critical to ensure optimum and
reliable wireless operation.
9.8 ft (3m)
Above Ground
U C I R R E M O T E C O N T R O L
NOTE: Unit can only be controlled with the UC IR remote when the
unit is set to Primary Mode.
STAND BY - Pressing this button will blackout the fixture. Press the button
again to return to the initial state.
FULL ON - Press this button down to fully light up the unit and stay full on.
DIMMER + and "DIMMER - - Use the buttons to adjust the UV color output
intensity when UV color mode is active.
STROBE - Press this button for strobing,then press button 1 to select slow
strobe speed,button 2 to select medium strobe speed,button 3 to select fast
strobe speed,button 4 to select faster strobe speed.
COLOR - Press this button to activate UV color mode.
1-4 BUTTONS - Use buttons 1-4 to select your desired strobe speed when
strobe mode is active.Use buttons 1-3 to select your desired strobe mode
when strobe mode is active.
FADE/GOBO - Press this button to activate strobe mode,then press button
1 to select random strobe mode,press button 2 to select pulse strobe
mode,press button 3 to select the normal strobe mode.
SOUND ON & OFF - Use the buttons to activate and deactivate sound
active strobe mode.
9